Coupler Pocket, 1-1/2" Scale

This coupler pocket is for appearance only, it does not support the coupler. It is large enough to cover the end of any of our tube frames or coupler mount, which will retain the coupler.

• Made of Aluminum - Furnished Machined but Not Drilled for Mounting Bolts (since this depends on your design) - Ready to Paint
• End Opening is 3/4" High to Fit Standard Coupler Shanks
• Overall Dimensions are 2" (50.8mm) High, 3.5" (88.9mm) Wide and 0.5" (12.7mm) Thick.
• Complete Installation Instructions Furnished

Furnished As Machined Parts - Modification and Installation Required